这渣笔记本,怎么回事啊

处男，无 · 发表于 2006-4-19 12:19

连接网络随机时间,随机数据传输量后随机自行切断,并没有“网络电缆被拔出”显示,而是直接就不能上网,192.168.1.1也进不去了.

网络肯定是正常的,因为旁边的机器可以上.
有大大分析是网卡出了问题,orz,真的么,换一个好麻烦啊.

前天开始下大婶.iso,彻夜开着早上起来一看发现切断了,重启后马上就好了,可是随机一段时间又RP = =

TifaRinoa · 发表于 2006-4-19 18:08

跟我的ADSL差不多,有时候网络传输速度快就容易掉线,关掉再开后正常
应该是硬件本身问题

Pluto_Shi · 发表于 2006-4-20 03:44

change receive buffer size to 64k

处男，无 · 发表于 2006-4-20 11:15

orz,搜索了一下,无果,改婶大大详细说说怎么改?

处男，无 · 发表于 2006-4-20 11:27

这个?

Pluto_Shi · 发表于 2006-4-20 12:55

网卡-属性-高级

处男，无 · 发表于 2006-4-20 13:21

处男，无 · 发表于 2006-4-20 13:27

我在4楼发的图就是进了网卡-属性-高级-performance options里面

= = 可是中英文混杂,我不确定\"接收描述符\"是不是就是\"receive buffer size\"
描述是

Sets the number of buffers used by the driver when copying data to the protocol memory. Increasing this value can enhance receive performance, but also consumes system memory.
Receive Descriptors are data segments that enable the adapter to allocate received packets to memory. Each received packet requires one Receive Descriptor, and each descriptor uses 2KB of memory.

You might choose to increase the number of Receive Descriptors if you notice a significant decrease in the performance of received traffic. If receive performance is not an issue, use the default setting.

Pluto_Shi · 发表于 2006-4-20 18:40

接合缓冲区

处男，无 · 发表于 2006-4-20 19:15

真是奇怪,那个设置的最大值为32,后面没有单位

Sets number of buffers available for transmit acceleration. Changing this setting can significantly increase transmit performance by customizing the number of Coalesce Buffers, which enable the adapter to join data segments before packet transmission.

To enhance performance, the Coalesce Buffers setting must be configured to work with the Transmit Descriptors setting. The Coalesce Buffers setting should be 30 - 50% of the Transmit Descriptors value. If the Coalesce Buffers setting is not modified to match the Transmit Descriptors setting, transmit performance might not be enhanced.

Recommended value 8

		自动登录	找回密码
密码			立即注册