婆罗门
精华
|
战斗力 鹅
|
回帖 0
注册时间 2007-11-22
|
出厂安卓11的机器分区改为virual a/b在这基础下的twrp有很多问题和限制
KNOWN LIMITATIONS:
The following are some known limitations due to either the design nature of Virtual A/B or a problem with ROM themselves. Please read carefully :-
You cannot format data after flashing a ROM zip (Limitation of Virtual A/B). If you want to format, then reboot recovery after flashing ROM. Additionally, if you are encrypted, the newly flashed ROM must be able to decrypt your device. If not, then you have to format data before flashing the ROM It appears, you can actually format data after reboot even if the new ROM cannot decrypt.
You can flash only one ROM in one boot. If you wanna flash another ROM, you must boot to system once. This is again a limitation of Virtual A/B.
Once you have rebooted after flashing a ROM, you cannot write to the data partition until you boot successfully to the new ROM. Android seals the data partition after a ROM flash to prevent any accidental brick since the newly flashed ROM is actually stored in /data. Only data format is allowed in this case. Once you successfully boot to the new ROM, your storage becomes ready for writing again.
Ideally, after flashing a new ROM, you should only need to wipe your data rather than format. But, due to a problem in the device trees current ROMs are using, you will have to format data if you are currently on miui and want to switch to a custom ROM. Specifically, the roms need this commit and to set vendor security patch level to fix this issue. Switching between custom ROMs should not need format, except for hentai OS.
If you are currently on hentai OS, then before using TWRP, you must flash vendor_boot from the link provided in every hentai OS release. Otherwise, you will get black screen. This is only needed when you boot to TWRP for the first time. Do not repeat this step again. Also, do not try this with beta version of the ROM. Use it only with stable.
If you reboot to older slot after flashing new ROM, the new ROM will be cancelled and you will have to reflash again. This is because of how Virtual A/B works.
If you must flash magisk via recovery (it's not recommended now), please uncheck "Inject TWRP after install" else TWRP will remove magisk.
Do not flash magisk after flashing a ROM before reboot. Magisk's zip detects slot in a different way that will cause issues.
Backuptool (used to persist magisk and gapps across ROM updates) will also not work in recovery due to A/B. You will have to flash gapps (or any other zips) everytime after flashing a ROM.
|
|
沪公网安备 31010702007642号 )
发表于 2021-11-6 02:02
而且刷机经常要清data
